AVR - Automatic Voltage Regulator GAVR-8A
The AVR GAVR-8A is a compact and robust voltage regulator offering precise regulation of <±1% for your generator. Its input is programmable (110/220/440 V CA), with voltage sensing at 110/220/400 V CA (1 phase, 2 wires) and a power input of 100-260 V CA. It provides a maximum output of 90 V CC to 240 V CA, with a continuous current of 3 A (5 A intermittent for 10 seconds). It includes soft start, low-frequency protection (55 Hz for 60 Hz; 45 Hz for 50 Hz), EMI suppression and a high-capacity built-in 8 A fuse. This AVR, with a maximum power dissipation of 8 watts, operates over a wide temperature range (-40 °C to +60 °C) and allows an external voltage adjustment of ±7%.
AVR - GAVR-8A is the automatic voltage regulator of the generator: it reads the output voltage and corrects the field excitation so the voltage stays stable as the load changes.
A failing AVR shows up before it dies: voltage dips 5–30 V when a large motor starts, lights flicker, or the control panel reboots. When it fails completely the set delivers only residual voltage or trips on overvoltage.
Specifications and compatibility
- Applicable to
- UNIVERSAL
- Dimensions
- 17 x 6 x 13 cm
- Weight
- 1.00 kg
How to verify before ordering
- Check that the reference printed on the AVR label (for example AS440, MX341, R120) matches exactly; variants differ in sensing range and excitation level.
- Confirm the excitation input voltage and the generator type it serves. They are not interchangeable across generator makes or speed ranges.
- Inspect wiring and brushes before replacing the module: a loose connection produces exactly the same symptoms as a burnt AVR.
Frequently asked questions
How do I know the fault is the AVR and not the generator?
Measure output voltage at steady load. If it is low and does not respond to the excitation trim, while windings and rotating diodes are healthy, the AVR is the suspect. A cross-test with a spare AVR confirms it in minutes.
Can the voltage be trimmed after installation?
Yes. Most of these regulators have a voltage and a stability trim pot. Set them at no load to the site nominal voltage, then verify under load before signing off.
Related parts
- AVR - Automatic Voltage Regulator STLF-3
- AVR - Automatic Voltage Regulator GB-130
- AVR - Automatic Voltage Regulator GAVR-20B
- AVR - Automatic Voltage Regulator GB-110
- AVR - Automatic Voltage Regulator GAVR-15 B
See the spare parts catalogue or request a quotation quoting the equipment reference. Third-party trademarks are cited for identification purposes only.
Specifications
| Characteristics | |
|---|---|
| Model | GAVR-8A |
| Applicable To | Universal |
| Weight | 1,00 kg |
| Dimensions | 17 x 6 x 13 cm |
| Spare Parts | |
|---|---|
| Generator Parts | AVR |
