AVR - Automatic Voltage Regulator GAVR-15 B
The AVR GAVR-15B/A is a universal voltage regulator for brushless generators, offering an accuracy of <±0.5% (or <±1% depending on the specific version) with the engine governed at 4%. This AVR has a voltage sensing input of 220/400 V CA (1 phase, 2 wires) and a power input of 180-260 V CA (1 phase, 2 wires), providing a maximum output of 90 V CC at 240 V CA, with a continuous current of 6 A and 12 A intermittent for 10 seconds. It includes 3 -second soft start, EMI suppression and low-frequency protection (knee point at 57 Hz for 60 Hz and 47 Hz for 50 Hz), and allows an external voltage adjustment of ±7%. Robust and efficient, it operates over a temperature range of -40°C to 65°C (storage from -40°C to 85°C), withstands 3G vibration and dissipates a maximum of 8 watts, with voltage build-up from 5 V CA residual.
AVR - GAVR-15 B/A belongs to the generator excitation circuit and holds the output voltage within about ±1 % when the load steps up or down.
AVR wear is thermal. It works inside the generator compartment with no ventilation of its own, so it is usually the first module to age on a high-hour set. Keeping one on the shelf avoids a multi-day stop for a low-cost part.
Specifications and compatibility
- Applicable to
- UNIVERSAL
- Dimensions
- 17 x 6 x 13 cm
- Weight
- 1.00 kg
How to verify before ordering
- Check that the reference printed on the AVR label (for example AS440, MX341, R120) matches exactly; variants differ in sensing range and excitation level.
- Confirm the excitation input voltage and the generator type it serves. They are not interchangeable across generator makes or speed ranges.
- Inspect wiring and brushes before replacing the module: a loose connection produces exactly the same symptoms as a burnt AVR.
Frequently asked questions
How do I know the fault is the AVR and not the generator?
Measure output voltage at steady load. If it is low and does not respond to the excitation trim, while windings and rotating diodes are healthy, the AVR is the suspect. A cross-test with a spare AVR confirms it in minutes.
Can the voltage be trimmed after installation?
Yes. Most of these regulators have a voltage and a stability trim pot. Set them at no load to the site nominal voltage, then verify under load before signing off.
Related parts
- AVR - Automatic Voltage Regulator DSR
- AVR - Automatic Voltage Regulator GAVR-20B
- AVR - Automatic Voltage Regulator AVC63-4
- AVR - Automatic Voltage Regulator STLF-3
- AVR - Automatic Voltage Regulator AS480
See the spare parts catalogue or request a quotation quoting the equipment reference. Third-party trademarks are cited for identification purposes only.
Specifications
| Characteristics | |
|---|---|
| Model | GAVR-15 |
| Applicable To | Universal |
| Weight | 1,00 kg |
| Dimensions | 17 x 6 x 13 cm |
| Spare Parts | |
|---|---|
| Generator Parts | AVR |
