Skip to Content

AVR - Automatic Voltage Regulator GB-110

https://www.bochipower.cc/web/image/product.template/938/image_1920?unique=9b4d277
(0 review)

The GB-110 Voltage Regulator is a high-performance device designed to provide a wide voltage adjustment range, from 50 V to 220 V, enabling precise control in a variety of applications. It incorporates a wave-voltage absorption circuit that effectively protects the high-power silicon-controlled rectifier, ensuring extended service life and durability. It is extremely versatile and can be used as a heat controller in electric stoves and water heaters, a light dimmer in lamps, a speed controller in small motors or a temperature controller in electric soldering irons, achieving dimming, temperature, voltage and speed effects. Always remember to disconnect the power supply before attempting any connection.

$ 94.35 94.35 USD Tax Excluded

94.35 Bs Tax Excluded

  • Model
  • Generator Parts
  • Applicable To
  • Weight
  • Dimensions

This combination does not exist.

Terms and Conditions
30-day money-back guarantee
Shipping: 2-3 Business Days

AVR - GB-110 is the automatic voltage regulator of the generator: it reads the output voltage and corrects the field excitation so the voltage stays stable as the load changes.

A failing AVR shows up before it dies: voltage dips 5–30 V when a large motor starts, lights flicker, or the control panel reboots. When it fails completely the set delivers only residual voltage or trips on overvoltage.

Specifications and compatibility

Applicable to
ESCOBILLA
Dimensions
17 x 8,5 x 13 cm
Weight
1.00 kg

How to verify before ordering

  • Check that the reference printed on the AVR label (for example AS440, MX341, R120) matches exactly; variants differ in sensing range and excitation level.
  • Confirm the excitation input voltage and the generator type it serves. They are not interchangeable across generator makes or speed ranges.
  • Inspect wiring and brushes before replacing the module: a loose connection produces exactly the same symptoms as a burnt AVR.

Frequently asked questions

How do I know the fault is the AVR and not the generator?

Measure output voltage at steady load. If it is low and does not respond to the excitation trim, while windings and rotating diodes are healthy, the AVR is the suspect. A cross-test with a spare AVR confirms it in minutes.

Can the voltage be trimmed after installation?

Yes. Most of these regulators have a voltage and a stability trim pot. Set them at no load to the site nominal voltage, then verify under load before signing off.

Related parts

See the spare parts catalogue or request a quotation quoting the equipment reference. Third-party trademarks are cited for identification purposes only.

Specifications

Characteristics
Model GB-110
Applicable To Carbon brush
Weight 1,00 kg
Dimensions 17 x 8,5 x 13 cm
Spare Parts
Generator Parts AVR