AVR - Automatic Voltage Regulator DSR
The AVR DSR is an advanced digital automatic voltage regulator that modernises generator control and is standard on the ECO and ECP models from Mecc Alte. This regulator simplifies the connection process thanks to its 15 "fast on/fast off" connectors, which is ideal for reconnecting 12 cable machines to different voltages. It is compatible with all ECO and ECP generators and works as standard with MAUX and PMG systems, removing the need to change the regulator. Its single-phase sensing is factory-set. In addition, the DSR allows external connection to a computer (via RS232 or USB) or to a PLC (via RS485 and MODBUS) through a communication card (DXR or Mecc Alte), making it possible to change settings, monitor performance in real time (voltage, frequency or DSR status) and download alarm reports with the DL1 software.
AVR - DSR is the automatic voltage regulator of the generator: it reads the output voltage and corrects the field excitation so the voltage stays stable as the load changes.
A failing AVR shows up before it dies: voltage dips 5–30 V when a large motor starts, lights flicker, or the control panel reboots. When it fails completely the set delivers only residual voltage or trips on overvoltage.
Specifications and compatibility
- Applicable to
- MECC ALTE
- Dimensions
- 17 x 6,5 x 13 cm
- Weight
- 2.00 kg
How to verify before ordering
- Check that the reference printed on the AVR label (for example AS440, MX341, R120) matches exactly; variants differ in sensing range and excitation level.
- Confirm the excitation input voltage and the generator type it serves. They are not interchangeable across generator makes or speed ranges.
- Inspect wiring and brushes before replacing the module: a loose connection produces exactly the same symptoms as a burnt AVR.
Frequently asked questions
How do I know the fault is the AVR and not the generator?
Measure output voltage at steady load. If it is low and does not respond to the excitation trim, while windings and rotating diodes are healthy, the AVR is the suspect. A cross-test with a spare AVR confirms it in minutes.
Can the voltage be trimmed after installation?
Yes. Most of these regulators have a voltage and a stability trim pot. Set them at no load to the site nominal voltage, then verify under load before signing off.
Related parts
- AVR - Automatic Voltage Regulator AVC63-4
- AVR - Automatic Voltage Regulator GAVR-15 B
- AVR - Automatic Voltage Regulator AS480
- AVR - Automatic Voltage Regulator GAVR-20B
- AVR - Automatic Voltage Regulator STLF-3
See the spare parts catalogue or request a quotation quoting the equipment reference. Third-party trademarks are cited for identification purposes only.
Specifications
| Characteristics | |
|---|---|
| Applicable To | MECC ALTE |
| Weight | 2,00 kg |
| Dimensions | 17 x 6,5 x 13 cm |
| Spare Parts | |
|---|---|
| Generator Parts | AVR |
