AVR - Automatic Voltage Regulator DVR2000E
The DVR2000E is a solid-state electronic voltage regulator, microprocessor-based, which controls the voltage output of brushless AC generators by adjusting the exciter field current. It is powered by a high-frequency, multi-pole permanent magnet generator (PMG). This AVR comes in an encapsulated package for behind-the-panel mounting, screwed to its plastic housing, and includes LED indicators that show generator and system status. Connections are made via quarter-inch quick-connect terminals on the rear panel, which also hosts a DB-9 9 -pin connector for PC communication. To comply with UL DVR2000E and prevent accidental contact with live terminals and heat sinks, the 509 is supplied with a moulded cover that must always be installed when power is applied.
AVR - DVR2000E belongs to the generator excitation circuit and holds the output voltage within about ±1 % when the load steps up or down.
AVR wear is thermal. It works inside the generator compartment with no ventilation of its own, so it is usually the first module to age on a high-hour set. Keeping one on the shelf avoids a multi-day stop for a low-cost part.
Specifications and compatibility
- Applicable to
- MARATHON ELECTRIC
- Dimensions
- 25 x 6 x 13 cm
- Weight
- 2.00 kg
How to verify before ordering
- Check that the reference printed on the AVR label (for example AS440, MX341, R120) matches exactly; variants differ in sensing range and excitation level.
- Confirm the excitation input voltage and the generator type it serves. They are not interchangeable across generator makes or speed ranges.
- Inspect wiring and brushes before replacing the module: a loose connection produces exactly the same symptoms as a burnt AVR.
Frequently asked questions
How do I know the fault is the AVR and not the generator?
Measure output voltage at steady load. If it is low and does not respond to the excitation trim, while windings and rotating diodes are healthy, the AVR is the suspect. A cross-test with a spare AVR confirms it in minutes.
Can the voltage be trimmed after installation?
Yes. Most of these regulators have a voltage and a stability trim pot. Set them at no load to the site nominal voltage, then verify under load before signing off.
Related parts
- AVR - Automatic Voltage Regulator DER1
- AVR - Automatic Voltage Regulator GAVR-12A
- AVR - Automatic Voltage Regulator DECS-100-B15
- AVR - Automatic Voltage Regulator R448
- AVR - Automatic Voltage Regulator M25FA600A
See the spare parts catalogue or request a quotation quoting the equipment reference. Third-party trademarks are cited for identification purposes only.
Specifications
| Characteristics | |
|---|---|
| Applicable To | BASLER ELECTRIC, MARATHON ELECTRIC |
| Model | DVR2000E |
| Weight | 2,00 kg |
| Dimensions | 25 x 6 x 13 cm |
| Spare Parts | |
|---|---|
| Generator Parts | AVR |
