AVR - Automatic Voltage Regulator R726
The AVR R726 is an add-on module that turns automatic voltage regulators such as the R129, R130, R438 and R450 into a "4 function" system, optimising their use on diesel generators, especially those paralleled to the grid. Besides voltage regulation (1st function), the R726 enables power factor regulation ("COS" or 2nd function) by means of an additional CT. The 3rd function is voltage matching (BALANCE) before paralleling with the grid (U=U), controlled by a synchroniser and the AVR's remote voltage trimmer. The 4th function allows parallel operation with other alternators fitted with the same R726 during voltage matching. It is a component used by generator set manufacturers and is compatible with models such as the AEM100RE001 AVR and the 330410293 AVR.
AVR - R726 is the automatic voltage regulator of the generator: it reads the output voltage and corrects the field excitation so the voltage stays stable as the load changes.
A failing AVR shows up before it dies: voltage dips 5–30 V when a large motor starts, lights flicker, or the control panel reboots. When it fails completely the set delivers only residual voltage or trips on overvoltage.
Specifications and compatibility
- Applicable to
- LEROY SEMER
- Dimensions
- 17 x 6 x 13 cm
- Weight
- 2.00 kg
How to verify before ordering
- Check that the reference printed on the AVR label (for example AS440, MX341, R120) matches exactly; variants differ in sensing range and excitation level.
- Confirm the excitation input voltage and the generator type it serves. They are not interchangeable across generator makes or speed ranges.
- Inspect wiring and brushes before replacing the module: a loose connection produces exactly the same symptoms as a burnt AVR.
Frequently asked questions
How do I know the fault is the AVR and not the generator?
Measure output voltage at steady load. If it is low and does not respond to the excitation trim, while windings and rotating diodes are healthy, the AVR is the suspect. A cross-test with a spare AVR confirms it in minutes.
Can the voltage be trimmed after installation?
Yes. Most of these regulators have a voltage and a stability trim pot. Set them at no load to the site nominal voltage, then verify under load before signing off.
Related parts
- AVR - Automatic Voltage Regulator GAVR-35A
- AVR - Automatic Voltage Regulator 314-7755
- AVR - Automatic Voltage Regulator R448
- AVR - Automatic Voltage Regulator DECS-100-B15
- AVR - Automatic Voltage Regulator DER1
See the spare parts catalogue or request a quotation quoting the equipment reference. Third-party trademarks are cited for identification purposes only.
Specifications
| Characteristics | |
|---|---|
| Model | R726 |
| Applicable To | LEROY SEMER |
| Weight | 2,00 kg |
| Dimensions | 17 x 6 x 13 cm |
| Spare Parts | |
|---|---|
| Generator Parts | AVR |
